Datasheet

TMC5160 DATASHEET (Rev. 1.01 / 2017-NOV-29) 35
www.trinamic.com
GENERAL CONFIGURATION REGISTERS (0X00…0X0F)
R/W
Addr
n
Register
Description / bit names
11..8
BBMCLKS:
0..15: Digital BBM time in clock cycles (typ. 83ns).
The longer setting rules (BBMTIME vs. BBMCLKS).
(Reset Default: OTP 4 or 2)
17..16
OTSELECT:
Selection of over temperature level for bridge disable,
switch on after cool down to 120°C / OTPW level.
00: 150°C
01: 143°C
10: 136°C (not recommended when VSA > 24V)
11: 120°C (not recommended, no hysteresis)
Hint: Adapt overtemperature threshold as required to
protect the MOSFETs or other components on the PCB.
(Reset Default = %00)
19..18
DRVSTRENGTH:
Selection of gate driver current. Adapts the gate driver
current to the gate charge of the external MOSFETs.
00: weak
01: weak+TC (medium above OTPW level)
10: medium
11: strong
Hint: Choose the lowest setting giving slopes <100ns.
(Reset Default = %10)
21..20
FILT_ISENSE:
Filter time constant of sense amplifier to suppress
ringing and coupling from second coil operation
00: low – 100ns
01: – 200ns
10: – 300ns
11: high – 400ns
Hint: Increase setting if motor chopper noise occurs
due to cross-coupling of both coils.
(Reset Default = %00)
W
0x0B
8
GLOBAL
SCALER
7..0
Global scaling of Motor current. This value is multiplied
to the current scaling in order to adapt a drive to a
certain motor type. This value should be chosen before
tuning other settings, because it also influences
chopper hysteresis.
0: Full Scale (or write 256)
1 … 31: Not allowed for operation
32 … 255: 32/256 … 255/256 of maximum current.
Hint: Values >128 recommended for best results
(Reset Default = 0)
R
0x0C
16
OFFSET_
READ
15..8
Offset calibration result phase A (signed)
7..0
Offset calibration result phase B (signed)