Datasheet

TMC5160 DATASHEET (Rev. 1.01 / 2017-NOV-29) 119
www.trinamic.com
27 Absolute Maximum Ratings
The maximum ratings may not be exceeded under any circumstances. Operating the circuit at or near
more than one maximum rating at a time for extended periods shall be avoided by application
design.
Parameter
Symbol
Min
Max
Unit
Supply voltage operating with inductive load
V
VS
, V
VSA
-0.5
60
V
Supply and bridge voltage short time peak (limited by
peak voltage on charge pump output and Cxx pins*)
V
VSMAX
64
V
VSA when different from to VS
V
VSAMAX
-0.5
60
V
Peak voltages on Cxx bootstrap pins and VCP
V
CxCP
76
V
Supply voltage V12
V
12VOUT
-0.5
14
V
Peak voltages on BM pins (due to stray inductivity)
V
BMx
-6
V
VS
+6
V
Peak voltages on Cxx bootstrap pins relative to BM
V
CxBMx
-0.5
16
V
I/O supply voltage on VCC_IO
V
VIO
-0.5
5.5
V
digital VCC supply voltage (normally supplied by 5VOUT)
V
VCC
-0.5
5.5
V
Logic input voltage
V
I
-0.5
V
VIO
+0.5
V
Maximum current to / from digital pins
and analog low voltage I/Os (short time peak current)
I
IO
+/-500
mA
5V regulator output current (internal plus external load)
I
5VOUT
30
mA
5V regulator continuous power dissipation (V
VSA
-5V) * I
5VOUT
P
5VOUT
1
W
12V regulator output current (internal plus external load)
I
5VOUT
20
mA
12V regulator continuous power dissipation (V
VM
-5V) * I
5VOUT
P
5VOUT
0.5
W
Junction temperature
T
J
-50
150
°C
Storage temperature
T
STG
-55
150
°C
ESD-Protection for interface pins (Human body model,
HBM)
V
ESDAP
4
kV
ESD-Protection for handling (Human body model, HBM)
V
ESD
1
kV
*) Stray inductivity of power routing will lead to ringing of the supply voltage when driving an
inductive load. This ringing results from the fast switching slopes of the driver outputs in
combination with reverse recovery of the body diodes of the output driver MOSFETs. Even small trace
inductivities as well as stray inductivity of sense resistors can easily generate a few volts of ringing
leading to temporary voltage overshoot. This should be considered when working near the maximum
voltage.
28 Electrical Characteristics
28.1 Operational Range
Parameter
Symbol
Min
Max
Unit
Junction temperature
T
J
-40
125
°C
Supply voltage for motor and bridge
V
VS
10
55
V
Supply voltage VSA
V
VSA
10
50
V
Supply voltage for VSA and 12OUT (internal gate voltage
regulator bridged)
V
12VOUT
,
V
VSA
10
13
V
Lower Supply voltage (reduced spec, short to GND
protection not functional), lower limit depending on
MOSFETs gate threshold voltage and load current
V
VS
8
V
I/O supply voltage on VCC_IO
V
VIO
3.00
5.25
V