Datasheet

TMC4671-EVAL Evaluation Board • Document Revision V1.0 • 2018-MAY-03
3 / 8
1 Getting Started
You need
• TMC4671-EVAL
• Landungsbruecke or Startrampe with latest
firmware (We recommend the Landungs-
bruecke as it offers faster USB communication.)
• 2 x Eselsbruecke
• TMC-UPS-2/24-EVAL or TMC-UPS-10A/70V-EVAL
• BLDC or Stepper motor with supported feed-
back system
• USB interface
• Power Supply
• Latest TMCL-IDE V3.0 and PC
• Cables for interface, motors and power
Precautions
• Do not mix up connections or short-circuit pins.
• Avoid bounding I/O wires with motor wires.
• Do not exceed the maximum rated supply sup-
ply voltage!
• Do not connect or disconnect the motor while
powered!
• START WITH POWER SUPPLY OFF!
Figure 1: Getting started
NOTICE
The Landungsbruecke operates on USB Power Supply. All other voltages are
generated from V_M. Kit works only, when V_M is applied.
©2018 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com