Datasheet

TMC2300-EVAL Evaluation Board • Document Revision V1.0 • 2019-SEP-02

3 / 11

1 Getting Started

You need

• TMC2300-EVAL

• Landungsbruecke with latest ﬁrmware. (The

Startrampe does not support the UART inter-

face.)

• Eselsbruecke bridge board

• Stepper motor (e.g. QMot line)

• USB interface

• Power Supply

• Latest TMCL-IDE V3.0 and PC

• Cables for interface, motors and power

Precautions

• Do not mix up connections or short-circuit pins.

• Avoid bundling I/O wires with motor wires.

• Do not exceed the maximum rated supply volt-

age!

• Do not connect or disconnect the motor while

powered!

• START WITH POWER SUPPLY OFF!

Figure 1: Getting started

Terms of delivery and rights to technical change reserved.

Download newest version at www.trinamic.com