User Manual

PD57/60-1260 CANopen
®
Firmware Manual • Firmware Version V3.21 | Document Revision V1.00 • 2017-DEC-21
105 / 117
9.1.5 Object 6064
h
: Position Actual Value
This object provides the actual value of the position measurement device. It always contains the same
value as object 6063
h
.
Object Description
Index Name Object Type Data Type
6064
h
Position Actual Value Variable SIGNED32
Table 318: Object Description (6064
h
)
Entry Description
Sub-index Access PDO Mapping Value Range Default Value
0 ro Refer to CiA402-3 SIGNED32 no
Table 319: Entry Description (6064
h
)
9.1.6 Object 606C
h
: Velocity Actual Value
This object shows the actual velocity value of the motor. The value is given in internal or user-defined
velocity units (depending on object 208C
h
, described in section 4.2.16).
Object Description
Index Name Object Type Data Type
606C
h
Velocity Actual Value Variable SIGNED32
Table 320: Object Description (606C
h
)
Entry Description
Sub-index Access PDO Mapping Value Range Default Value
0 ro Refer to CiA402-3 SIGNED32 no
Table 321: Entry Description (606C
h
)
9.1.7 Object 607A
h
: Target Position
The target position is the position that the drive should move to in cyclic synchronous position mode using
the current interpolation time period. In csp mode this value is always interpreted as an absolute value.
Object Description
Index Name Object Type Data Type
607A
h
Target Position Variable SIGNED32
Table 322: Object Description (607A
h
in csp Mode)
©2018 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com