User Manual

PD42-x-1240 Hardware Manual • Hardware Version V1.20 | Document Revision V1.10 • 2018-DEC-05
7 / 34
A cable loom set is available for this module:
Order Code Description
TMCM-1240-CABLE Cable loom for TMCM-1240:
• 1x cable loom for power supply connector (cable length 200mm, 4pin
JST PH connector at one end, open wires at the other end)
• 1x cable loom for RS485 + CAN connector (cable length 200mm, 5pin
JST PH connector at one end, open wires at the other end)
• 1x cable loom for motor connector (cable length 200mm, 4pin JST PH
connector at one end, open wires at the other end)
• 1x cable loom for I/O connector (cable length 200mm, 8pin JST PH
connector at one end, open wires at the other end)
• 1x Micro-USB cable
Table 2: TMCM-1240 Cable Loom
The TMCM-1240 controller/driver electronics is also available separately. Please refer to TMCM-1240
hardware manual for further details.
©2018 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com