Datasheet

PD20-1-1210 Hardware Manual • Hardware Version V1.10 | Document Revision V1.20 • 2019-APR-03
13 / 24
node
n - 1
node
n
Slave Slave
termination
resistor
(120R)
+5V
GND
pull-up (680R)
pull-down (680R)
RS485- / RS485B
termination
resistor
(120R)
RS485+ / RS485A
Figure 7: RS485 bus lines with resistor (bias) network on one side, only
Or add resistor network at both ends of the bus (like Profibus™ termination):
node
n - 1
node
n
Slave Slave
termination
resistor
(220R)
+5V
GND
pull-up (390R)
pull-down (390R)
RS485- / RS485B
RS485+ / RS485A
termination
resistor
(220R)
+5V
GND
pull-up (390R)
pull-down (390R)
Figure 8: RS485 bus lines with Profibus™recommended line termination
9 Motor driver current
The on-board stepper motor driver operates current controlled. The driver current may be programmed
in software with 32 effective scaling steps in hardware.
Explanation of different columns in table below:
Motor current set-
ting in software
(TMCL)
These are the values for TMCL axis parameter 6 (motor run current) and
7 (motor standby current). They are used to set the run / standby current
using the following TMCL commands:
SAP 6, 0, <value> // set run current
SAP 7, 0, <value> // set standby current
(read-out value with GAP instead of SAP. Please see separate PD20-1-1210
firmware manual for further information)
Motor current I
RMS
[A]
Resulting motor current based on motor current setting
©2019 TRINAMIC Motion Control GmbH & Co. KG, Hamburg, Germany
Terms of delivery and rights to technical change reserved.
Download newest version at www.trinamic.com