User manual

PDx-113-57/60-SE / TMCM-113-57/60-SE Firmware Manual (V1.10 / 2009-OCT-28) 19

this case every character that is entered is echoed back when the module is addressed. A Character can also

be erased using the backspace character (press the backspace key in a terminal program). When bit 4 is set

and bit 5 is clear the characters that are entered are not echoed back immediately but the entire line will be

echoed back after the <CR> character has been sent. When bit 5 is set and bit 4 is clear there will be no

echo, only the reply will be sent. This may be useful in RS485 systems.