User manual

PD-1021 TMCL Firmware V1.19 Manual (Rev. 1.01 / 2012-JUL-30) 7
www.trinamic.com
2. Switch ON the power supply
Turn power ON. The green LED for power lights up and the motor is powered but in standstill
now.
If this does not occur, switch power OFF and check your connections as well as the power
supply.
2.1.2 Start the TMCL-IDE Software Development Environment
The TMCL-IDE is available on www.trinamic.com.
Installing the TMCL-IDE:
Make sure the COM port you intend to use is not blocked by another program.
Open TMCL-IDE by clicking TMCL.exe.
Choose Setup and Options and thereafter the Connection tab.
Choose COM port and type with the parameters shown in Figure 2.2 (baud rate 9600). Click OK.
Figure 2.2 Setup dialogue and connection tab of the TMCL-IDE.
Please refer to the TMCL-IDE User Manual for more information (see www.TRINAMIC.com).