User manual

TMCM-1180 and PD86-1180 TMCL Firmware V4.42 Manual (Rev. 1.08 / 2012-NOV-20) 22
www.trinamic.com
5.7 Commands
The module specific commands are explained in more detail on the following pages. They are listed according
to their command number.
5.7.1 ROR (rotate right)
With this command the motor will be instructed to rotate with a specified velocity in right direction
(increasing the position counter).
Internal function: First, velocity mode is selected. Then, the velocity value is transferred to axis parameter #0
(target velocity).
The module is based on the TMC428-I stepper motor controller and the TMC262A-PC power driver. This makes
possible choosing a velocity between 0 and 2047.
Related commands: ROL, MST, SAP, GAP
Mnemonic: ROR 0, <velocity>
Binary representation:
INSTRUCTION NO.
TYPE
MOT/BANK
VALUE
1
(don't care)
0*
<velocity>
0… 2047
*motor number is always O as only one motor is involved
Reply in direct mode:
STATUS
VALUE
100 – OK
(don't care)
Example:
Rotate right, velocity = 350
Mnemonic: ROR 0, 350
Binary:
Byte Index
0
1
2
3
4
5
6
7
8
Function
Target-
address
Instruction
Number
Type
Motor/
Bank
Operand
Byte3
Operand
Byte2
Operand
Byte1
Operand
Byte0
Checksum
Value (hex)
$01
$01
$00
$02
$00
$00
$01
$5e
$62