User's Manual

TrimTrac ProE Locator Technical Manual v2.0e 193
Vehicle Adapter or Control Module Parameter Ranges and Default Settings
Parameter Unit/Notes Default Messages Commands
HPA Idle Timeout, T11 In Seconds (10-999990) 10
MPA Idle Timeout, T12 In Seconds (10-999990) 10
HPA Delay Timeout, T13 In Seconds (10-86400) 10
MPA Delay Timeout, T14 In Seconds (10-86400) 10
HPA Transmit Timeout, T15 0=Infinity; Else in Seconds (10-999990) 0
MPA Transmit Timeout, T16 0=Infinity; Else in Seconds (10-999990) If not set
0-Infinity, should be set no lower than 300
Seconds.
300
HPA Query Timeout, T17 In Seconds (10-3600) 60
HPA Transmit Attempts, N5 0=Until T15 Expires; 1-255=Number of Tx
Attempts before T15 expires
0
MPA Transmit Attempts, N6 0=Until T16 Expires; 1-255=Number of Tx
Attempts before T16 expires
0
LPA Transmit Attempts, N7 0=Until T3 Expires; 1-255=Number of Tx Attempts
before T3 expires
0
HPA Mode 0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only
0
MPA Mode 0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only.
WARNING: Before inserting a Vehicle Adapter
or Control Module:
A) Connect the red (+) and black (-) wires to a
9-32 VDC power source and install a 100k Ohm
resistor across the yellow wires; OR
B) Return MPA Mode to its default setting
“1=Disabled”.
1
LPA Mode 0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only (regardless of
motion)
0
>STKY
>QKTY
>RTKY
AT+CTKY
Table 94, Vehicle Adapter or Control Module Parameters and Defaults.