User's Manual

TrimTrac ProE Locator Technical Manual v2.0e 175
RESP_GEOFENCE_CONFIG
This is the response message to the SET_GEOFENCE _CONFIG (page 154)and
QUERY_GEOFENCE_CONFIG (page 162) message containing the Geofence
Parameter values. It is also sent with any REPORT_POS and STATUS_MSG
having TriggerType set “2=Exception Report Alert” and Geofence Status set
“1=Violation” or “5=New LPA-based Geofence”, except when some other new
event, such as a Speed Violation, has triggered the REPORT_POS OR
STATUS_MSG. The RESP_GEOFENCE_CONFIG message sent with either a
REPORT_POS OR STATUS_MSG will be for the geofence most recently
violated or boundary most recently crossed.
>RTKABBCDEEEEEFFFFFGGGHHHHHHHIIIIJJJJJJJ;ID=YYYYYYYY;*
ZZ<
A
TrimTrac ProE Configuration Set: ‘K’ = Geofence Parameters
BB
Geofence ID: Unique geofence identifier 1 or 2.
C
Geofence Enforcement: 0=Disabled; 1=Enforced; 2=LPA Input
Enforced; 3=LPA Centered and Enforced.. Default 0
D
Geofence Schedule: 0=24/7; 1=After Scheduled Hours; 2=
During Scheduled Hours. (See Scheduled Hours Mode). Default:
0
EEEEE
Geofence Delta X: 100s of meters (1 – 10000) Note: East-West
length of rectangular Geofence area or, if circular, the diameter.
1=100 Meters. Default 1.
FFFFF
Geofence Delta Y: 100s of meters (0, 1 – 10000) Note: If set to
“0”, then circular Geofence area; else rectangular Geofence area.
1=100 Meters
GGG.HHHH
HHH
Geofence Center Latitude: WGS-84 Coordinates. Units of Degrees
to 7 decimal places plus ‘+’ sign = North and ‘-‘ = South.
(-90.0000000 to +90.0000000)
. Default +0.0000000.
IIII.JJJ
JJJJ
Geofence Center Longitude: WGS-84 Coordinates. Units of
Degrees to 7 decimal places plus ‘+’ sign = East and ‘-‘ = West.
(-180.0000000 to +180.0000000)
. Default +0.0000000
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 79, RESP_GEOFENCE_CONFIG Message