User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 82
Provisioning AT Commands
AT Command Summary
The following AT commands are used to provision and configure the TrimTrac
1.5 via HyperTerminal when connected to the Provisioning Module.
Command
Description See Page
AT+CTKC
Assigns Application parameters
AT+CTKC?
Queries Application parameters
83
AT+CTKE
Restores Factory Defaults and/or Erases Message Log 85
AT+CTKF
Assigns GPRS Connection parameters
AT+CTKF?
Queries GPRS Connection parameters
85
AT+CTKJ
Assigns GPRS Setup parameters
AT+CTKJ?
Queries GPRS Setup parameters
87
AT+CTKG
Assigns GPS parameters
AT+CTKG?
Queries GPS parameters
88
AT+CTKK
Assigns Geofence parameters
AT+CTKK?
Queries Geofence parameters
89
AT+CTKP
Assigns SMS Communication parameters
AT+CTKP?
Queries SMS Communication parameters
91
AT+CTKX
Assigns Extended Application parameters
AT+CTKX?
Queries Extended Application parameters
93
AT+CTKY
Assign Vehicle Adapter and Control Module
parameters
AT+CTKY?
Queries Vehicle Adapter and Control Module
parameters
97
AT+CTKZ
Assigns Extended 2 Application parameters
AT+CTKZ?
Queries Extended 2 Application parameters
99
AT+CTKO?
Retrieves Logged Messages 91
ATI
Queries Firmware Version 101
Table 20, Summary of AT Commands