User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 70
ii. If Position Age is set “0=Current”, then go to the IDLE state
upon expiration of MPA Delay Timeout, T14.
c. “3=Acknowledged”, then go to the IDLE state upon expiration of
DELAY Timeout, T4.
7.
Proceed immediately to the IDLE state whenever:
a. The LPA switch is in its “armed” closed position regardless of how
the LPA Status is set.
b. LPA Status is set “1=Activated” regardless of the LPA switch
position (“unarmed” open or “armed” closed).
8. All Delay Timeouts (T4, T13 and T14) are immediately terminated
whenever any alert status state (HPA Status, MPA Status or LPA Status) is
or becomes set to “1=Activated” and the unit immediately transitions to
the IDLE state.