User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 36
Vehicle Adapter or Control Module Equipped Units
PLEASE CONNECT ALL WIRE LEADS PRIOR TO INSERTING THE VEHICLE
ADAPATER MODULE INTO THE TRIMTRAC 1.5 BASE
REQUIRED CONNECTIONS:
1. Connect RED wire to a constant, non-switched 9-32 VDC source of
power (+).
2. Connect the BLACK wire to vehicle ground.
3. Connect YELLOW wires as follows:
a. Connect YELLOW wires to High, Medium and/or Low
Priority Alert devices as described in the OPTIONAL INPUTS
AND ALERTS below; OR.
b. Cut or tape off the YELLOW wires. Make sure the TrimTrac
1.5 is programmed to Disable Medium Priority Alerts.
OPTIONAL INPUTS AND ALERTS:
1. Refer to the wiring diagram provided in the Technical Manual, Figure
9, Vehicle Adapter Module Alert Wiring Diagram.
2. Mount the monitored switches or devices in the desired locations. It is
best to install resistors with the values specified on the wiring diagram
at the monitored switch or device (instead of at the TrimTrac 1.5). In
so doing, maximum tampering protection is afforded.
3. Install a 100K-Ohm End-of-Line resistor as shown in the wiring
diagram.
FINAL ASSEMBLY AND INSTALLATION:
1. Configure and provision the TrimTrac 1.5 as described in the TrimTrac
Technical Manual. As a minimum, the device must be provisioned
with a Destination Address and, if required by the SIM card provider, a
SIM PIN, even if all other factory default settings are used.
2. Remove the TrimTrac 1.5 base cover and any previously installed
module to access the SIM cardholder.
3. Insert the activated SMS-enabled SIM card from your service provider
or wireless carrier into the SIM cardholder and close latch making sure
the SIM card is securely seated and locked into place.
4. Remove rubber channel plug from the TrimTrac 1.5 base unit (near the
cover screw insert)