User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 35
Summary End-user and Installation Instructions
Battery Powered Units
1. Configure and provision the TrimTrac 1.5 as described in the TrimTrac
Technical Manual. As a minimum, the device must be provisioned
with a Destination Address and, if required by the SIM card provider, a
SIM PIN, even if all other factory default settings are used.
2. If SIM card is already installed, remove the TrimTrac 1.5 base cover
and any installed modules to access the SIM cardholder.
3. Insert the activated SMS-enabled SIM card from your service provider
or wireless carrier into the SIM cardholder and close latch making sure
the SIM card is securely seated and locked into place.
4. Place the empty Battery Module in the TrimTrac 1.5 base while
aligning the arrow on Battery Module with the arrow on the TrimTrac
1.5 base.
5. Press down on the Battery Module to snap it securely in place on all
four corners making sure all corner clip tabs are all fully engaged.
6. Insert four fresh AA alkaline batteries into the Battery Module with
polarities as shown on the Battery Module.
Note: The LED may or may not immediately begin flashing when
the unit is shaken depending upon which operational state the
device may have been in when batteries were inserted.
7. Install TrimTrac 1.5 base cover and tighten the hold down screw.
8. Place the TrimTrac 1.5 at a slight incline (TrimTrac logo facing up)
with as clear of a view of the sky as possible.
9. To change batteries, remove the TrimTrac 1.5 base cover and properly
dispose of old batteries, then follow steps 6 through 8 above.