User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 12
Parameter Settings Msg. Header
(See Page)
Commands
( See Page)
Geofence ID Unique geofence identifier 1 or 2
Geofence
Enforcement
0=Disabled; 1=Enforced 24/7;
2=LPA Input Enforced; 3=LPA
Centered and Enforced.
Geofence
Delta X
100s of meters (1 – 10000) Note:
East-West length of rectangular
Geofence area or, if circular, the
diameter. 1=100 Meters
Geofence
Delta Y
100s of meters (0, 1 – 10000) Note:
If set to “0”, then circular Geofence
area; else rectangular Geofence area.
1=100 Meters
Geofence
Center
Latitude
WGS-84 Coordinates. Units of
Degrees to 7 decimal places plus ‘+’
sign = North and ‘-‘ = South.
(-90.0000000 to +90.0000000)
Geofence
Center
Longitude
WGS-84 Coordinates. Units of
Degrees to 7 decimal places plus ‘+’
sign = East and ‘-‘ = West.
(-180.0000000 to +180.0000000)
>STKK (117)
>QTKK (123)
>RTKK (134)
AT+CTKK
(89)
Geofence
Type
0=Boundary Crossing; 1=Inclusive;
2=Exclusive
Automatic
Message Log
Dump
0=Disabled; 1=Enabled
>STKZ (116)
>QTKZ (123)
>RTKZ (133)
AT+CTKZ
(99)
Report Delay
Flag
0=Transmit All Messages;
1=Transmit Alert, Query response
and Scheduled messages only;
2=Transmit Motion-related AND
Alert, Query response and
Scheduled messages only; 3=
Transmit IDLE Timeout, T1, Status
Messages AND Alert, Query
response and Scheduled messages
only; 4=Start/Stop Reporting; 5=Log
5 messages, transmit next; 6=Log 10
messages, transmit next
>STKA (113)
>QTKA (123)
>RTKA (130)
AT+CTKC
(83)
Table 2. Geofence Parameters, Settings, Messages and Commands