User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 151
Parameter Unit/Notes Default Messages Commands
Dynamic Motion Filter
Counter, N4
In Seconds (1-90). Note: This parameter is enabled only
when Dynamic Filter Timeout, T21, is active.
WARNING: Dynamic Motion Filter Counter, N4, must
always be set equal to or less than the setting for Dynamic
Filter Timeout, T21; else the unit may not exit QUERY
state..
10
Motion Sensor Override 0=Normal; 1=Motion Always; 2=Motion Never. Note:
Overrides the motion sensor if set to a value other than
“0=Normal”..
0
>STKX
>QTKX
>RTKX
AT+CTKX
Table 85, Enhanced Feature Parameters and Defaults.