User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 149
Enhanced Feature Parameter Ranges and Default Settings
Parameter Unit/Notes Default Messages Commands
Scheduled Reporting
Mode
0=None; 1=Daily; 2=Weekly 0
Scheduled Report Time,
T18
In Seconds (0-604799). Note: This is either the seconds into
the day or into the week for the device to schedule
transmission of a STATUS_MESSAGE plus the most
recently logged POSITION_REP, if any, when this feature is
enabled. If Scheduled Reporting Mode is set “0=None”,
then enter 0.
0
In-Motion Polling 0=Disabled; 1=OnDemand while in Motion. Note: If set to
“1=OnDemand while in Motion”, the unit is able to receive
and process data messages ONLY while in motion regardless
of current state.
0
Anytime Polling 0=Disabled; 1=Duty-Cycled while in IDLE State;
2=Anytime OnDemand. Note: If set to “2=Anytime
OnDemand”, the unit is able to receive and process data
messages regardless of motion, current state or how In-
Motion Polling is set. If set “1=Duty-Cycled”, unit is able to
receive and process data messages while in QUERY or
whenever while Polling Duty-Cycle On-Time, T20, is
running.
0
Polling Duty-Cycle
Frequency, T19
In Seconds (10-999990). Note: Determines how frequently
the Polling Duty-Cycle On-Time, T20, timer is started if and
only if the Anytime Polling is set to “1=Duty-Cycled while
in IDLE State” and device is NOT in motion.
3600
Polling Duty-Cycle On-
Time, T20
In Seconds (0, 10-3600). Note: Determines how long after
expiration of Polling Duty-Cycle Frequency, T19, timer that
the unit is able to receive and process data messages. A
value of zero causes the QUERY Timeout, T5, value to be
used.
60
>STKX
>QTKX
>RTKX
AT+CTKX