User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 148
Basic State Machine Parameters, Messages and Commands
Parameter Unit/Notes Default Messages Commands
IDLE Timeout, T1 In seconds (10 – 999990) 43200
FIX Timeout, T2 In seconds (10 – 3600) 300
TRANSMIT Timeout, T3 In seconds (10 – 3600) 120
DELAY Timeout, T4 In seconds (10 – 86400) 900
QUERY Timeout, T5 In seconds (10 – 3600) 60
Almanac Timeout, T6 In hours (10 – 990) 168
Static Motion Filter
Timeout, T7
In seconds (0 – 90). Note: T7 is used exclusively while in
the IDLE state; however, it is superseded by the Dynamic
Filter Timeout, T21, whenever Anytime Polling is:
A. Set “2=Anytime OnDemand”; OR
B. Set “1-Duty-Cycled” and Polling Duty-Cycle On-Time,
T20, is running.
Always set Static Motion Filter Timeout, T7, greater than
or equal to Static Motion Filter Counter, N3.
20
Motion Report Flag 0=None; 1=Report Motion in IDLE (before attempting
new GPS fix)
0
Report Delay Flag 0=Transmit All Messages; 1=Transmit Alert, Query
response and Scheduled messages only; 2=Transmit
Motion-related AND Alert, Query response and Scheduled
messages only; 3= Transmit IDLE Timeout, T1, Status
Messages AND Alert, Query response and Scheduled
messages only; 4=Start/Stop Reporting; 5=Log 5
messages, transmit next; 6=Log 10 messages, transmit next
0
Diagnostics Mode 0= None; 1= LED 1
Communication Mode 0= SMS; 1= GPRS; 2=AutoSelect 0
>STKA
>QTKA
>RTKA
AT+CTKC
Table 84, Basic State Machine Parameters, Messages and Command