User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 140
RESP_CONTROL_OUTPUT
This is the by the TrimTrac 1.5 in response to the SET_CONTROL_OUTPUT or
QUERY_CONTROL_OUTPUT messages.
>RTKABCDDDDDDDDDDDDDDDD;ID=YYYYYYYY;*ZZ<
A
Always ‘U’: Indicates a set Control Module output message.
B
Output 1: 0=Output Low; 1=Output High; 2=No Module
Attached0=Output Low; 1=Output High; 2=No Change; 3=No
Module Attached
C
Output 2:
DDDDDDDDD
DDDDDDD
Reserved for future use. Must be sent as ‘0000000000000000’.
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 80, RESP_MODULE_OUTPUT Message