User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 139
RESP_MODULE_APP
This is the by the TrimTrac 1.5 in response to the
SET_MODULE_APP_CONFIG and QUERY_CONFIG message.
>RTKABBBBBBCCCCCCDDDDDDEEEEEEFFFFFFGGGGGGHHHHHHIIIJJJKKKLMN;ID=YY
YYYYYY;*ZZ<
A
MODULE-only Configuration Set: ‘Y’ = MODULE-only
Parameters
BBBBBB
HPA Idle Timeout, T11. In Seconds (10-999990)
CCCCCC
MPA Idle Timeout, T12. In Seconds (10-999990)
DDDDDD
HPA Delay Timeout, T13. In Seconds (10-86400)
EEEEEE
MPA Delay Timeout, T14. In Seconds (10-86400)
FFFFFF
HPA Transmit Timeout, T15. 0=Infinity; Else in Seconds (10-
999990)
GGGGGG
MPA Transmit Timeout, T16. 0=Infinity; Else in Seconds
(10-999990)
HHHHHH
HPA Query Timeout, T17. In Seconds (10-3600)
III
HPA Transmit Attempts, N5. 0=Until T15 Expires; 1-
255=Number of Tx Attempts before T15 expires
JJJ
MPA Transmit Attempts, N6. 0=Until T16 Expires; 1-
255=Number of Tx Attempts before T16 expires
KKK
LPA Transmit Attempts, N7. 0=Until T3 Expires; 1-
255=Number of Tx Attempts before T3 expires
L
HPA Mode. 0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only
M
MPA Mode. 0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only.
WARNING: Before inserting a Vehicle Adapter or Control
Module:
A) Connect the red (+) and black (-) wires to a 9-32 VDC
power source and install a 100k Ohm resistor across the
yellow wires; OR
B) Return MPA Mode to its default setting “1=Disabled”.
N
LPA Mode. 0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only (regardless of motion)
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 79, RESP_MODULE_APP Message