User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 133
RESP_EXT2_APP_CONFIG
This is the response message to the SET_EXT2_APP_CONFIG and
QUERY_CONFIG message containing the Extended 2 Application Parameter
values.
>RTKABBBBCDDDDDEEEEEFGHIJJJKKKLMNNNO;ID=YYYYYYYY;*ZZ<
A
TrimTrac-1.5 Configuration Set: ‘Z’ = Extended 2
Application Parameters
BBBB
Motion Counter Threshold: Counter (1-2000). Default 10
C
Scheduled Hours: 0=Disabled; 1=Enabled. Default 0
DDDDD
Daily Start Time, T27: In Seconds (0 – 86399) after 12:00AM
UTC.. Default 0
EEEEE
Work Day Length, T28: In Seconds (0 – 86400). Default
43200
F
First Work Day of Each Week: 0=Sunday; 1=Monday;
2=Tuesday; 3=Wednesday; 4=Thursday; 5=Friday; 6=Saturday
(All relative to UTC). Default1
G
Number of Work Days per Week: 1= One Day; 2=Two Days;
3=Three Days; 4=Four Days; 5=Five Days; 6=Six Days; 7=Seven
Days. Default 5
H
Runtime Meter Motion-based: 0=Disabled; 1=Enabled.
Default 0.
I
Runtime Meter LPA-based: 0=Disabled; 1=Enabled. Default 0
JJJ
Runtime Meter Motion-based Countdown, T29: In Hours
(0=No Countdown, 1-990). Default 0
KKK
Runtime Meter LPA-based Countdown, T30: In Hours (0=No
Countdown, 1-990). Default 0
L
Automatic Message Log Dump: 0=Disabled; 1=Enabled.
Default 0
M
GPS Fix Rate: 0=GPS operation during FIX State only; 1=1Hz
GPS operation except while stationary. Default 0
NNN
LPA Input Arming Delay, T31: In Seconds (0-990). Default 0
0
Geofence Type: 0=Boundary Crossing; 1=Inclusive;
2=Exclusive
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 70, RESP_EXT2_APP_CONFIG Message