User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 129
RESP_ALERT_STATE
The TrimTrac 1.5 sends this message after a SET_ALERT_STATE request is
received and processed; provided, however, that the TrimTrac 1.5 is connected to
a Vehicle Adapter or Control Module. If battery powered, then this message will
not be sent upon receipt of a SET_ALERT_STATE request.
>RTKABCD;ID=YYYYYYYY;*ZZ<
A
Always ‘L’: Indicates operation mode setting
B
HPA Status
. 0=Normal; 1=Activated; 2=Sent; 3=Acknowledged;
4=Monitor Activated
C
MPA
Status. 0=Normal; 1=Activated; 2=Sent; 3=Acknowledged;
4=Monitor Activated
D
LPA Status
. 0=Normal; 1=Activated; 2=Sent; 3=Acknowledged;
4=Monitor Activated
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 67, RESP_ALERT_STATE Message