User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 127
Position, Status and Response Messages
REPORT_POS and STATUS_MSG
These two messages are the most common. The difference between the
REPORT_POS and STATUS_MSG is that the REPORT_POS message contains
position information. STATUS_MSG does not contain any position.
>RTKABBBBCDDDEFFFFGGGGGGSTVOPQRWXUUU[HHHIIIIIIIJJJJKKK
KKKKLLLLLLMMMNNN];ID=YYYYYYYY;*ZZ<
A
TrimTrac Report Type: ‘P’ = Position Report
‘S’ = Status Report
BBBB
Protocol Sequence Number. 16-bit Hex (0000-FFFF) incrementing
by 1 for each logged report.
C
TriggerType
0=IDLE Timeout
1=Motion Detected
2=Alert set “Activated” (Modules-Only)
3=Query
4=Scheduled Report
5=Runtime Meter
Report
6=Stop Motion Report
DDD
Battery Level. 0-100%.
E
Battery Changed Flag. T=True;
F=False
FFFF
GPS Week Number. Always 4 Digits
GGGGGG
GPS Seconds into Week. Always 6 Digits.
S
GPS Status Code.
0=3D GPS Fix
1=2D GPS Fix
2=Fix Timeout, 0 SVs
3=Fix Timeout, 1 SV
4=Fix Timeout, 2 SVs
5=Fix Timeout, 3 SVs
6=GPS Error
7=No Fix attempted
T
GSM Status Code
0=Network Available
1=Message Logged (i.e. Report Delay Flag set=1)
2=Network Timeout
3=SIM Error / No SIM
4=SIM PIN Error
5=Pre-TX log (Low battery)
V
Position Age: 0=Current (i.e. no motion since last position)
1=Aged (i.e. motion has occurred since last position)
O
HPA Status: 0=Normal; 1=Activated; 2=Sent;
3=Acknowledged; 4=Monitor Activated
P
MPA Status: 0=Normal; 1=Activated; 2=Sent;