User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 126
b. QUERY_POSITION Operation Mode is set “P=Compute New
Position Fix”.
The new STATUS_MSG will have the TriggerType set to “3=Query” and the
Position Aged flag will be set ‘1’=Aged if there has been motion since the last
logged position; else the Position Aged flag will be set “1=Current”.
>QTKABCCCC;PW=PPPPPPPP;ID=YYYYYYYY;*ZZ<
A
Always ‘D’: Indicates a query Position message.
B
Position Query Mode. S=Compute if Position Aged;
P=Compute New Position Fix; L=Status Report with Last
logged position
CCCC
Position Query Fix Timeout. In Seconds (10-3600). Note:
Temporarily overrides current FIX Timeout, T2, if Position
Query Mode set to “S=Compute” and report current position.
Settings longer than 600 minutes are generally not
recommended. No default value.
PPPPPPPP
Security Password
. Always 8 alphanumeric characters, UPPER
CASE ONLY.
. Default 00000000
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 64, QUERY_POSITION Message
QUERY_CONTROL_OUTPUT
This message is sent by the server to request the current state of the Control
Module Outputs. TrimTrac responds by sending RESP_CONTROL_OUTPUT
message.
>RTKA;ID=YYYYYYYY;*ZZ<
A
Always ‘U’: Indicates a query Control Module output message.
PPPPPPPP
Security Password
. Always 8 alphanumeric characters, UPPER
CASE ONLY.
. Default 00000000
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 65, QUERY_CONTROL_OUTPUT Message