User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 120
SET_GPS_CONFIG
The SET_GPS_CONFIG message is used by the server application to set the
TrimTrac GPS parameter values in the TrimTrac 1.5. When received the
TrimTrac 1.5 will send a RESP_GPS_CONFIG message in response. Please note
that these GPS configuration parameters will seldom need to be changed from
default values. It is NOT recommended that they be changed without first
consulting with your Trimble representative.
>STKABBCCCDDDEEEF;PW=PPPPPPPP;ID=YYYYYYYY;*ZZ<
A
TrimTrac Configuration Set: ‘G’ = GPS Parameters
BB
GPS Elevation Mask. In degrees (0-30). Default 5
CCC
GPS PDOP Mask. In tenths of PDOP (60 – 200). Default 120
DDD
GPS PDOP Switch. In tenths of PDOP (40 – 120). Default 60
EEE
GPS Signal Mask. In tenths of AMUs (10 – 80). Default 10
F
GPS Dynamics Mode. (Do Not Change). Default 5
PPPPPPPP
Security Password. Always 8 alphanumeric characters, UPPER CASE
ONLY.
. Default 00000000
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 56, SET_GPS_CONFIG Message
SET_PROV_CONFIG
The SET_PROV_CONFIG message is used by the server application to set the
SMS Communication values in the TrimTrac 1.5. When received by the
TrimTrac 1.5, the unit will send a RESP_PROV_CONFIG message in response.
>STKABBBBBBBBBBBBBBBBBBBBBBBB;PW=PPPPPPPP;ID=YYYYYYYY;
*ZZ<
A
TrimTrac Configuration Set: ‘V’ = Provisioning
Parameters
BBBBBB
BBBBBB
BBBBBB
BBBBBB
SMS Destination Address. 24 characters including optional
international dialing “+” sign and country code for SMS messages..
Field padding in SPACES (not 0’s) before the international
dialing “+” sign. Default <Empty>.
PPPPPPPP
Security Password. Always 8 alphanumeric characters, UPPER
CASE ONLY.
Default 00000000
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 57, SET_PROV_CONFIG Message