User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 117
SET_GEOFENCE_CONFIG
This message is used to set up a Geofence in the TrimTrac-1.5 device. When
received the TrimTrac-1.5 device will send a RESP_GEOFENCE_CONFIG
message in response. Please note that all geofences must be the same type
(Boundary Crossing, Exclusive, Inclusive) as determined by either
SET_EXT2_APP_CONFIG or AT+CTKZ.
>STKABBCDEEEEEFFFFFGGGHHHHHHHIIIIJJJJJJJ;PW=PPPPPPPP;I
D=YYYYYYYY;*ZZ<
A
TrimTrac-1.5 Configuration Set: ‘K’ = Geofence Parameters
BB
Geofence ID: Unique geofence identifier 1 or 2. Default 1
C
Geofence Enforcement: 0=Disabled; 1=Enforced 24/7; 2=LPA
Input Enforced; 3=LPA Centered and Enforced.. Default 0
D
Reserved. Default: 0
EEEEE
Geofence Delta X: 100s of meters (1 – 10000) Note: East-West
length of rectangular Geofence area or, if circular, the diameter.
1=100 Meters. Default 1.
FFFFF
Geofence Delta Y: 100s of meters (0, 1 – 10000) Note: If set to
“0”, then circular Geofence area; else rectangular Geofence area.
1=100 Meters
GGG.HHHH
HHH
Geofence Center Latitude: WGS-84 Coordinates. Units of Degrees
to 7 decimal places plus ‘+’ sign = North and ‘-‘ = South.
(-90.0000000 to +90.0000000)
. Default +0.0000000
IIII.JJJ
JJJJ
Geofence Center Longitude: WGS-84 Coordinates. Units of
Degrees to 7 decimal places plus ‘+’ sign = East and ‘-‘ = West.
(-180.0000000 to +180.0000000)
. Default +0.0000000
PPPPPPPP
Security Password. Always 8 alphanumeric characters, UPPER CASE
ONLY.
. Default 00000000
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 53, SET_ GEOFENCE_CONFIG Message