User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 113
SET_APP_CONFIG
The SET_APP_CONFIG message is used by the server application to set the
primary state machine parameters in the TrimTrac 1.5. When received the
TrimTrac 1.5 will send a RESP_APP_CONFIG message in response.
>STKABBBBBBCCCCCCDDDDDDEEEEEEFFFFFFGGGTTHIJK;PW=PPPPPPP
P;ID=YYYYYYYY;*ZZ<
A
TrimTrac Configuration Set: ‘A’ = Application Parameters
BBBBBB
IDLE Timeout, T1. In seconds (10 – 999990).
Default 43200
CCCCCC
FIX Timeout, T2. In seconds (10 – 3600).
Default 300
DDDDDD
TRANSMIT Timeout, T3. In seconds (10 – 3600).
Default 120
EEEEEE
DELAY Timeout, T4. In seconds (10 – 86400). Default 900
FFFFFF
QUERY Timeout, T5. In seconds (10 – 3600). Default 60
GGG
Almanac Timeout, T6. In hours (10 – 990). Default 168
TT
Static Motion Filter Timeout, T7. In seconds (0 – 90). Note: T7 is
used exclusively
while in the IDLE state; however, it is superseded by
the Dynamic Filter Timeout,
T21, whenever Anytime Polling is:
A. Set “2=Anytime OnDemand”; OR
B. Set “1-Duty-Cycled” and Polling Duty-Cycle On-Time, T20, is
running.
Always set Static Motion Filter Timeout, T7, greater than or equal to
Static
Motion Filter Counter, N3. Default 20
H
Motion Report Flag. 0=None; 1=Report Motion in IDLE (before
attempting new GPS fix)
. Default 0
I
Report Delay Flag. 0=Transmit All Messages; 1=Transmit Alert, Query
response and Scheduled messages only; 2=Transmit Motion-related AND
Alert, Query response and Scheduled messages only; 3= Transmit IDLE
Timeout, T1, Status Messages AND Alert, Query response and Scheduled
messages only; 4=Start/Stop Reporting; 5=Log 5 messages, transmit next;
6=Log 10 messages, transmit next
. Default 0
J
Diagnostics Mode. 0= None; 1= LED. Default 1
K
Communication Mode. 0= SMS; 1= GPRS; 2=AutoSelect.
Default 0
PPPPPPPP
Security Password. Always 8 alphanumeric characters, UPPER CASE
ONLY.
Default 00000000
YYYYYYYY
Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.
Table 50, SET_APP_CONFIG Message