User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 98
AT+CTKY?
CTKY: <HPA Idle Timeout, T11>,<MPA Idle Timeout, T12>,<HPA Delay
Timeout, T13>,<MPA Delay Timeout, T14>,<HPA Transmit Timeout,
T15>,<MPA Transmit Timeout, T16>,<HPA Query Timeout, T17>,<HPA
Transmit Attempts, N5>,<MPA Transmit Attempts, N6>,<LPA Transmit
Attempts, N7>,<HPA Mode>,<MPA Mode>,<LPA Mode>
OK
<HPA Idle Timeout, T11> In Seconds (10-999990). Default 10
<MPA Idle Timeout, T12> In Seconds (10-999990). Default 10
<HPA Delay Timeout, T13> In Seconds (10-86400). Default 10
<MPA Delay Timeout, T14> In Seconds (10-86400). Default 10
<HPA Transmit Timeout, T15> 0=Infinity; Else in Seconds (10-999990). Default 0
<MPA Transmit Timeout, T16> 0=Infinity; Else in Seconds (10-999990). Default 120
<HPA Query Timeout, T17> In Seconds (10-3600). Default 60
<HPA Transmit Attempts, N5> 0=Until T15 Expires; 1-255=Number of Tx Attempts
before T15 expires. Default
0
<MPA Transmit Attempts, N6> 0=Until T16 Expires; 1-255=Number of Tx Attempts
before T16 expires. Default
0
<LPA Transmit Attempts, N7> 0=Until T3 Expires; 1-255=Number of Tx Attempts
before T3 expires. Default
0
<HPA Mode>
0=Automatic; 1=Disabled;
2=Network
Acknowledgement; 3= Monitor-only. Default 0
<MPA Mode> 0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only.
WARNING: Before inserting a Vehicle
Adapter or Control Module:
A) Connect the red (+) and black (-) wires to a
9-32 VDC power source and install a 100k
Ohm resistor across the yellow wires; OR
B) Return MPA Mode to its default setting
“1=Disabled”.
. Default 1.
<LPA Mode>
0=Automatic; 1=Disabled;
2=Network
Acknowledgement; 3= Monitor-only (regardless
of motion)
. Default 0
Table 38, AT+CTKY? Query