User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 95
AT+CTKX?
+CTKX: <Scheduled Reporting Mode>,<Scheduled Report Time, T18>,<In-
Motion Polling>,<Anytime Polling>,<Polling Duty-Cycle Frequency,
T19>,<Polling Duty-Cycle On-Time, T20>,<Query Hold
Flag>,<Reserved>,<Position Report Transmit Attempts, N1>,<Status Message
Transmit Attempts, N2>,<Static Motion Filter Counter, N3>,<Dynamic Filter
Timeout, T21>,<Dynamic Motion Filter Counter, N4>,<Motion Sensor Override>
OK
<Scheduled Reporting
Mode>
0=None; 1=Daily; 2=Weekly. Default
0
<Scheduled Report Time,
T18>
In Seconds (0-604799).
Note: This is either the seconds
into the day or into the week for the device to schedule
transmission of a STATUS_MESSAGE plus the most
recently logged
POSITION_REP, if any, when this feature
is enabled. If Scheduled
Reporting Mode is set “0=None”,
then enter 0. Default
0
<In-Motion Polling> 0=Disabled; 1=OnDemand while in Motion. Note: If set to
“1=OnDemand while in Motion”, the unit is able to receive
and process data messages
ONLY while in motion
regardless of current state. Default 0
<Anytime Polling>
0=Disabled; 1=Duty-Cycled while
in IDLE State;
2=Anytime OnDemand. Note: If set to “2=Anytime
OnDemand”, the unit is able to receive and process
data messages regardless of motion, current state or
how In-Motion Polling is set. If set “1=Duty-Cycled”,
unit is able to receive and process data messages while
in QUERY or whenever while Polling Duty-Cycle On-
Time, T20, is running.. Default 0
<Polling Duty-Cycle
Frequency,
T19>
In Seconds (10-999990).
Note: Determines how frequently
the Polling Duty-Cycle On-Time, T20, timer is started if and
only if the Anytime Polling is set
to “1=Duty-Cycled
while in IDLE State” and device is NOT in motion.
Default
3600
<Polling Duty-Cycle On-
Time,
T20>
In Seconds (0,
10-3600). Note: Determines how long after
expiration of Polling Duty-Cycle Frequency, T19, timer that
the unit is able to receive and process data messages. A
value of zero
causes the QUERY Timeout, T5, value to be
used.
Default 60
<Query Hold Flag> 0=Disabled; 1=Enabled. Note: Unit attempts to reconnect to
the GSM network if the connection is lost during the
QUERY state prior to the expiration of QUERY Timeout,
T5.
Default 0
<Reserved>
0=Formerly “Extended
Motion Detection” in TrimTrac 1.0
Not used in TrimTrac 1.5.
Default 0
<Position Report Transmit 0=Until T3 Expires; 1-255=Number of Tx Attempts.