User's Manual

DRAFT TrimTrac 1.5 Technical Manual v0.3ab 89
AT+CTKK Geofence Configuration
The AT+CTKK command configures the Geofence parameters. All Geofences
must be the same type as defined in AT+CTKZ or SET_EXT2_APP_CONFIG.
AT+CTKK=<Geofence ID>,<Geofence Enforcement>,<Reserved>,<Geofence
Delta X>,<Geofence Delta Y>,<Geofence Center Latitude>,<Geofence Center
Longitude>
OK
<Geofence ID> Unique geofence identifier 1 or 2. Default: 1
<Geofence Enforcement > 0=Disabled; 1=Enforced 24/7; 2=LPA Input
Enforced; 3=LPA Centered and Enforced.. Default:
0
<Reserved> Future Use. Default: 0
<Geofence Delta X> 100s of meters (1 – 10000) Note: East-West length
of rectangular Geofence area or, if circular, the
diameter. 1=100 Meters. Default: 1
<Geofence Delta Y> 100s of meters (0, 1 – 10000) Note: If set to “0”,
then circular Geofence area; else rectangular
Geofence area. 1=100 Meters Default: 1
<Geofence Center Latitude> WGS-84 Coordinates. Units of Degrees to 7
decimal places plus ‘+’ sign = North and ‘-‘ =
South.
(-90.0000000 to +90.0000000). Must be in quotation
marks. Default: “
+0.0000000”
<Geofence Center
Longitude>
WGS-84 Coordinates. Units of Degrees to 7
decimal places plus ‘+’ sign = East and ‘-‘ = West.
(-180.0000000 to +180.0000000). Must be in
quotation marks. Default: “
+0.0000000”
Table 30, AT+CTKK Assignment
Default: AT+CTKK=1,0,0,1,1,”+0.0000000”,”+0.0000000”