User's Manual

DRAFT TrimTrac Locator Technical Manual 42
No Modem Connection with Server Application
If it appears that you have no modem connection with the Server Application,
confirm that the Server Application modem is configured correctly and that the
TrimTrac locator is configured and operating correctly. Do the following:
1. Check to see if the Destination Address is programmed correctly.
2. Verify the Server Application software is calling the correct TrimTrac
locator telephone number and using the correct Unit ID, Security Password and
SIM PIN, if used.
Server Application Software
Confirm the proper Server Application software setup. The Server Application
software may not be correctly integrated with the TrimTrac locator. Contact your
software vendor for assistance.
Updating Firmware in the Field
You can upload new firmware from a PC or laptop connected to the Provisioning
Module. For more information on updating firmware in the field, refer to the
Trimble Web site: http://www.trimtrac.com
LED Indicator
The LED indicator is useful for diagnosing problems. For more information, see
LED States, page 14. If you detect a problem, then have the TrimTrac locator
inspected by qualified service personnel.