User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
CrossCheck CDPD Mobile Unit Manual
65
Specifications
A
Table A.4 GPS Antenna Requirements
Item Specification
Antenna Impedance 50 Ω
Antenna RF Gain 20 dBi minimum gain, measured at the input connector to the
CrossCheck CDPD
Noise Figure 2.5 dB maximum, measured at the input connector to the
CrossCheck CDPD
VSWR 2:1 Max over range
Power 5.0 ±0.5 VDC @ 40 mA maximum on center conductor
Table A.5 CDPD Cellular Specifications
Item Specification
Cellular CDPD Specification 1.0 and 1.1, 600 mW Full Duplex
Frequencies Transmit: 824 to 849 MHz
Receive: 869 to 894 MHz
Receiver Sensitivity –111 dBm
Type Approvals FCC Part 15 Class B and Part 22 (from OEM module)
FCC ID = JUPCCKCDPD
Industry Canada