User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
CrossCheck CDPD Mobile Unit Manual
63
Specifications
A
Table A.1 General Specifications
Item Specification
Power Requirements
Transmitting
- without Mobile Data Terminal: Typical 450 mA
(1.5 A peak) at 12 V (Transmitter at max power level)
Transmitting
- with Mobile Data Terminal: Typical 520 mA
(1.6 A peak) at 12 V (Transmitter at max power level)
Idle
(not transmitting) - without Mobile Data Terminal: Typical
130 mA at 12 V
Idle
(not transmitting) - with Mobile Data Terminal: Typical
200 mA at 12 V
Sleepmode
(all functions off, IGN sense and inputs active):
< 10 mA at12 V
MDT Port (1) RS-232 DCE
Serial Port Speed (bps) 9600
Data Rate over the Air 19,200 bps maximum
Discrete I/O Ports Discrete Inputs: (4) switch closures; ignition
Pulse Counting Inputs (3) minimum pulse width:
500 microseconds
Outputs: (3) 200 mA low-side drivers, Auxiliary output for
sensors: 100 mA max at 8.5 ±0.5 V
Status LEDs GPS (green) and CDPD (amber)