User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
CrossCheck CDPD Mobile Unit Manual
57
Operation
3
Figure 3.1 shows the CrossCheck CDPD LED indicators.
Figure 3.1 CrossCheck CDPD LED Indicators
3.2.1
LED States
The GPS and CDPD LED have three states: On, Off, and Blink.
When both LED indicators are off, the CrossCheck CDPD’s power is
off. When one or more LED indicators are on or blinking, the power
is on.
3.2.2
LED Power-On Sequence
When the CrossCheck CDPD’s ignition input and power inputs are
activated:
• The LEDs blink once.
• Both turn off for approximately 5 seconds.
• Both remain on for approximately 2 seconds.
Warning: All persons must
be at least 20 cm from
antenna when transmitter
operating to meet FCC RF
exposure requirements.
GPS LED (Green)
CDPD LED (Amber)