User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
3
Operation
56
CrossCheck CDPD Mobile Unit Manual
3.1
Introduction
Once you have installed and configured the CrossCheck CDPD, it is
ready for operation. When power is applied, the CrossCheck CDPD
operates automatically without user intervention, based on its
firmware configuration.
This chapter provides a basic overview of the CrossCheck CDPD’s
operation, including:
• LED Indicators
• GPS Receiver
• CDPD Transceiver
3.2
LED Indicators
The CrossCheck CDPD includes two LED indicators: GPS and GSM.
The firmware:
• Continuously monitors the GPS receiver and the
CrossCheck CDPD phone operation
• Controls the two LED indicators