User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
CrossCheck CDPD Mobile Unit Manual
53
Installation
2
• Sharp or abrasive surfaces
• Door and window jambs
• Corrosive fluids or gases
Follow these installation guidelines:
• Choose the most direct path to the destination.
• Leave enough excess cable for a service loop, to allow for
removal of the EchoLDX and the CrossCheck.
• Secure the cable to the pedestal with a cable tie.
Power and Interface Connections
The 2.90 m Power/Data cable provided with the EchoLDX includes a
RJ-45 connector at one end and a serial connection and a DB9M at the
other (as shown in Figure 2.27).
Figure 2.27 Echo
LDX
Power/Data Cable