User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
2
Installation
52
CrossCheck CDPD Mobile Unit Manual
4. Place the pedestal base on the mounting surface and secure it
with the appropriate screws.
Figure 2.26 Echo
LDX
Attached to Mounting Assembly
5. Affix the MDT to the mounting pedestal. Position the MDT and
tighten all locking nuts.
2.11.5
Routing the Power/Data Cable
The next step in the installation process is to route the Power/Data
cable from the EchoLDX to the CrossCheck. When routing the cable,
avoid the following hazards:
• Sharp bends or kinks in the cable
• Hot surfaces (exhaust manifolds or stacks)
• Rotating or reciprocating equipment