User Manual

2
Installation
50
CrossCheck CDPD Mobile Unit Manual
2.11
Installing the Echo LDX Kit
The EchoLDX Message Terminal can be installed in almost any type
of vehicle. There are four steps in this procedure:
1. Assemble the mounting pedestal.
2. Mount the EchoLDX.
3. Route the Power/Data cable.
4. Connect the Power/Data cable to the CrossCheck CDPD.
This section provides detailed installation instructions.
2.11.1
Configuration Parameters
In addition to the physical installation of the unit, configuration
parameters can be set in each unit. Trimble recommends that if a
configuration other than the factory setting is used, every unit in the
fleet be given the same settings so that operation is consistent from
vehicle to vehicle. EchoLDX configuration is discussed in the
EchoLDX Message Terminal for CrossCheck CDPS and CrossCheck
GPRS Installation and User’s Manual,
Trimble Part Number 46667-
00-ENG.
2.11.2
Preparing for Installation
Inventory
Prior to installation, confirm that you have received the required
EchoLDX components:
• EchoLDX Message Terminal
• Power/Data cable
• EchoLDX mounting pedestal kit (6") and mounting hardware
• EchoLDX Quick Reference Guide