User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
vi
CrossCheck CDPD Mobile Unit Manual
Inspecting and Unpacking the Shipment . . . . . . . . . . . . . . . . 14
Installer-Supplied Parts . . . . . . . . . . . . . . . . . . . . . . . . . 15
Mounting the CrossCheck CDPD. . . . . . . . . . . . . . . . . . . . 16
Connecting CrossCheck CDPD to the Vehicle Chassis . . . . . 18
Direct Connection through Mounting Screws . . . . . 19
Connection through the Chassis Ground Wire . . . . . 19
Choosing the GPS Antenna Mounting Location . . . . . . . . . . . . 20
Miniature BulkHead GPS Antenna with Flange (P/N 31192-00) 25
Miniature Bulkhead GPS Antenna without Flange (P/N 32434) 27
Miniature Magnetic GPS Antenna (P/N 37167) . . . . . . . . . 28
Routing the GPS Antenna Cable . . . . . . . . . . . . . . . . . . . . 30
Choosing a CDPD Cellular Antenna Mounting Location . . . . . . . 31
Magnetic Cellular Antenna (P/N 46721). . . . . . . . . . . . . 33
Bulkhead Cellular Antenna (P/N 46730) . . . . . . . . . . . . 34
Routing the Cellular Antenna Cable . . . . . . . . . . . . . . . 38
Connecting the Magnetic Cellular Antenna Cable. . . . . . . . 39
Connecting the Permanent-Mount Cellular Cable . . . . . . . . 39
Inputs (IP0 to IP3) . . . . . . . . . . . . . . . . . . . . . . . . 40
Pulse Counting Inputs (Pulse 0 to Pulse 2) . . . . . . . . . . . 41
Outputs (XP0 to XP2) . . . . . . . . . . . . . . . . . . . . . . 42
CrossCheck CDPD Power . . . . . . . . . . . . . . . . . . . . . . . 44
Connections For Power Management . . . . . . . . . . . . . . 46
Continuous Power Connection (No Power Management) . . . . 48
Installing the EchoLDX Kit . . . . . . . . . . . . . . . . . . . . . . . 50
Configuration Parameters . . . . . . . . . . . . . . . . . . . . 50
Preparing for Installation. . . . . . . . . . . . . . . . . . . . . 50
Inventory . . . . . . . . . . . . . . . . . . . . . . . . 50
Choosing a Location . . . . . . . . . . . . . . . . . . . . . . . 51
Mounting the Pedestal and Installing the EchoLDX. . . . . . . 51
Routing the Power/Data Cable. . . . . . . . . . . . . . . . . . 52
3 Operation
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 56