User Manual

CrossCheck CDPD Mobile Unit Manual
45
Installation
2
Figure 2.23 illustrates the power and I/O cable.
Figure 2.23 Power and I/O Cable (P/N 46598-00)
Note – Trimble recommends installing the power and ground leads as
close to the battery as possible to ensure that the CrossCheck CDPD is
connected to the cleanest possible source of power.
1 Vbat Red Input Power 9-32V
2 GND Black
3 GND Green Chassis GND
4 GND
Blk/White
GND
5 White Ignition Sense Input
6 Blue Input 3
7 Purple Input 2
8 Orange Discrete Output 2
9
IP1
Input 1
10 Gray Discrete Output 1
11 Purple/White Input 0
12 Brown Discrete Output 0
4
6
8
10 12
1
2
3
57
9
11
14 16
Connector
Molex Micro-Fit 3.0 16-Pin
Molex P/N 43025-1600
Pins
Molex Female
templated Contact
Molex P/N 43030-0001
Side View
Yellow
XP1
IP0
XP0
IGN
IP3
IP2
XP2
13 Pulse 0 Brn/White Pulse Counter Input 0
14 Pulse 1 Gray/White Pulse Counter Input 1
15 Pulse 2 Orange/White Pulse Counter Input 2
16 8V AUX Red/White 8 VDC Auxiliary Input
Batt.GND
Pulse 0
Pulse 1
Pulse 2
8V Aux
Batt. GND
Chassis GND
GND
IGN
IP3
IP2
XP2
IP1
XP1
IP0
XP0
V
Batt.
2A @ 250V Blade Type
156"
13
15
Front View