User Manual

CrossCheck CDPD Mobile Unit Manual
35
Installation
2
3. Position the cable mounting assembly below the 19 mm
(0.75 in.) hole from the interior of the vehicle (see Figure 2.15).
Figure 2.15 Mounting the Antenna Cable Assembly
Two people may be required to perform this operation,
depending on the vehicle location where the antenna is
mounted.
4. Re-install the brass nut from the exterior of the vehicle (see
Figure 2.16). Turn the brass nut until the cable mounting
assembly is secured in place. The brass nut must make metal-to-
metal contact with the vehicle's sheet metal to allow the o-ring
to seal properly.
Figure 2.16 Re-installing the Brass Nut
1
2
3
4