User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
CrossCheck CDPD Mobile Unit Manual
33
Installation
2
2.9.1
Magnetic Cellular Antenna (P/N 46721)
The Magnetic-Mount Cellular antenna and Magnetic Base (see
Figure 2.13) is designed for temporary mounting on any ferrous
surface.
Figure 2.13 Magnetic Cellular Antenna
The antenna features a 3.5 m (11.5 ft.) integral coaxial cable
terminated with a TNC-M connector, which is compatible with the
CrossCheck CDPD’s Cellular Antenna connector. The antenna’s
magnetic base adheres to any ferrous surface and requires no fasteners
or mounting hardware.
Magnetic Base
Magnetic Mount
Cellular Antenna