User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
CrossCheck CDPD Mobile Unit Manual
27
Installation
2
2.7.2
Miniature Bulkhead GPS Antenna without Flange
(P/N 32434)
Two cables are available for the Miniature Bulkhead Antenna
without Flange:
• A straight TNC-Plug-to-SMA-Plug antenna cable (P/N 36107)
• A right-angle TNC-Plug-to-straight-SMA-Plug antenna cable
(P/N 36106)
Check the metal thickness at the mounting location before drilling the
mounting hole. The bulkhead mount on the antenna is designed to
attach to metal surfaces with a thickness of 48 mm (0.1875 in.) or less.
Figure 2.10 illustrates the antenna without the flange. For more
information, see Appendix A.
Figure 2.10 Miniature Bulkhead GPS Antenna without Flange (P/N 32434)
Gasket
Sheet Metal
Mounting Nut
Jam Nut
Metal Washer










