User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
CrossCheck CDPD Mobile Unit Manual
25
Installation
2
2.7.1
Miniature BulkHead GPS Antenna with Flange
(P/N 31192-00)
Two cables are available for the Miniature Bulkhead Antenna with
Flange:
• A straight TNC-Plug-to-SMA-Plug antenna cable (P/N 36107)
• A right-angle TNC-Plug-to-straight SMA-Plug antenna cable
(P/N 36106)
For more information, see Appendix A.
Figure 2.8 shows the Miniature Bulkhead GPS antenna mounting.
Figure 2.8 Miniature Bulkhead GPS antenna with Flange (P/N 31192-00)
Mounting hardware.
Only two of four sets
shown for clarity.
Gasket
Cable
Mounting Lug