User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
CrossCheck CDPD Mobile Unit Manual
21
Installation
2
Additional guidelines to follow include:
• Mount the antenna in a horizontal position facing the sky, as
shown in Figure 2.5.
If the antenna must be located in the vicinity of other antennas
(radio, cellular phone), locate the GPS antenna at least 46 cm
(approximately 18 in.) away.
• Avoid areas of high vibration (for example, engine hoods).
For permanent installations, choose a location with access both
above and below the antenna-mounting surface. This access is
required for installing fasteners and for routing the antenna
cable.
Note – The standard length of magnetic-mount and bulkhead-
mount GPS antenna cables supplied by Trimble is 5 m
(approximately 16 ft.). Longer bulkhead-mount antenna cables
can be prepared by the installer using the guidelines presented
in Appendix A.