User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
CrossCheck CDPD Mobile Unit Manual
13
Installation
2
Figure 2.2 illustrates the power and discrete I/O pinout.
Figure 2.2 Power and Discrete I/O Pinout
2.3.3
GPS Antenna
The GPS antenna uses an SMA female connector. For more
information, see Appendix A.
2.3.4
MDT Port
Figure 2.3 illustrates the MDT port pin configuration, a standard 9-pin
DCE configuration.
Figure 2.3 MDT Pinout
12108642
1197531
14
16
13
15
12345
6789










