User Manual
Table Of Contents
- CrossCheck® CDPD
- Warranties and Notices
- Regulatory Approvals
- Contents
- About this Manual
- Chapter 1 - Overview
- Chapter 2 - Installation
- Introduction
- Installing the CrossCheck CDPD Mobile Unit
- CrossCheck CDPD Connections
- Inspecting and Unpacking the Shipment
- Installer-Supplied Parts
- Mounting the CrossCheck CDPD
- Choosing the GPS Antenna Mounting Location
- Routing the GPS Antenna Cable
- Choosing a CDPD Cellular Antenna MountingLocation
- Caution – FCC RF Exposure requirements
- Magnetic Cellular Antenna (P/N 46721)
- Bulkhead Cellular Antenna (P/N 46730)
- Routing the Cellular Antenna Cable
- Connecting the Magnetic Cellular Antenna Cable
- Connecting the Permanent-Mount Cellular Cable
- Inputs (IP0 to IP3)
- Pulse Counting Inputs (Pulse 0 to Pulse 2)
- Outputs (XP0 to XP2)
- CrossCheck CDPD Power
- Installing the EchoLDX Kit
- Chapter 3 - Operation
- Appendix A - Specifications
- Reader Comment Form
CrossCheck CDPD Mobile Unit Manual
11
Installation
2
2.3
CrossCheck CDPD Connections
This section describes the CrossCheck CDPD component
connections. Figure 2.1 shows the CrossCheck CDPD connections.
Figure 2.1 CrossCheck CDPD Connections
2.3.1
CDPD Antenna
The CrossCheck CDPD uses a TNC connector for the CDPD antenna.
For more information, see Appendix A.
1
2
3
4
Warning: All persons must
be at least 20 cm from
antenna when transmitter
operating to meet FCC RF
exposure requirements.
1
Antenna TNC receptacle
2
MDT port
3
GPS antenna
4
Power and discrete I/O