User's Manual
Table Of Contents
- Juno SA handheld User Guide
- Legal Notices
- Safety Information
- Contents
- Introduction
- Getting Started
- Using the Windows Mobile Operating System
- Connecting to an Office Computer
- Using the GPS Receiver
- Troubleshooting
Juno SA Handheld User Guide 51
Connecting to an Office Computer 4
Connecting the handheld to a computer
To connect the Juno SA handheld to a computer:
1. Make sure that the handheld and the computer are switched on.
2. Make sure you have installed the appropriate connection management software
onto the computer (see Connection management software, page 50).
3. Connect the USB data cable to the USB port on the handheld.
4. Connect the other end of the USB data cable to a USB port on the computer.
When the handheld and the computer are connected, you can manage the
connection through a window that appears on the office computer. See one of
the following:
– Managing the connection using the Windows Mobile Device Center,
page 51
– Managing the connection using ActiveSync technology, page 53
Managing the connection using the Windows Mobile Device
Center
1. Connect the handheld to the computer (see page 51).
2. If the Autoplay window appears, close the window.